Bill Calfee
Gun Fool
Calfee XP #10
CYA accuracy fool friends:
Larry Parsons owns Calfee XP #10...
After Larry left the match in Arizona, he went directly to the Lapua test center with Calfee XP#10....
The test folks aren't used to ammo testing a pistol, and they did the best they could in figuring a way to mount the pistol in their test vise.
They wound up clamping the pistol by the 3 inch X 1/2 inch rail that the bi-pod attaches to.....
This rail is held to the stock by two, small 8x32 screws.....
So the entire weight of the pistol was being held by these two, small screws....again, the tester did the best he could....I'll give him much credit for that...
Now here's the blow your mind part of this story...
With that pistol being held by two, small 8x32 screws, look at the test it kicked out....I blocked the lot number out cause it also shot killer in Chisum...
Larry said the tester said he'd never seen anything like it........
That's getting mighty close to the eleven MM range......being held by just those two, small screws....amazing..
CYA accuracy fool friends:
These pistols don't back up from no rifles....anywhere.
This amazing test is just another reason I want to see a MD-PAS ignition pistol for the masses.....
Your pistol fool friend, Bill Calfee
_________________________
PS:
Larry will be shooting the Arizona State ARA match tomorrow, then he'll drive the seven hours to shoot in California Sunday..
CYA accuracy fool friends:
Larry Parsons owns Calfee XP #10...
After Larry left the match in Arizona, he went directly to the Lapua test center with Calfee XP#10....
The test folks aren't used to ammo testing a pistol, and they did the best they could in figuring a way to mount the pistol in their test vise.
They wound up clamping the pistol by the 3 inch X 1/2 inch rail that the bi-pod attaches to.....
This rail is held to the stock by two, small 8x32 screws.....
So the entire weight of the pistol was being held by these two, small screws....again, the tester did the best he could....I'll give him much credit for that...
Now here's the blow your mind part of this story...
With that pistol being held by two, small 8x32 screws, look at the test it kicked out....I blocked the lot number out cause it also shot killer in Chisum...
Larry said the tester said he'd never seen anything like it........
That's getting mighty close to the eleven MM range......being held by just those two, small screws....amazing..
CYA accuracy fool friends:
These pistols don't back up from no rifles....anywhere.
This amazing test is just another reason I want to see a MD-PAS ignition pistol for the masses.....
Your pistol fool friend, Bill Calfee
_________________________
PS:
Larry will be shooting the Arizona State ARA match tomorrow, then he'll drive the seven hours to shoot in California Sunday..